The 24mm Brushless Drive Kit comes with two Rectified 24mm Brushless Drives, two 35A BLheli-32 ESCs preprogrammed for bidirectional operation, and two power distribution boards. This means that all you have to do is solder the motors to the ESCs, wire in your battery, and plug them into your receiver to have a fully operational brushless drive for your Beetleweight.
- 2x Rectified Robotics 24mm Brushless Drive
- 2x 35A BLHeli_32 ESC - Preprogrammed Bidirectional
- 1x Rectified Robotics Power Distribution Board pair
Note: If only running "Opto" ESCs (only two wires in PWM cable), you will need a BEC to power your radio receiver. We provide a powerful BEC here.
Battle Hardening Recommendations:
All motors come with Loctite applied. Loctite 263 is used on the motor gearbox interface, Loctite 243 is used to retain the 4 gearbox screws.
To remove the motor from the mounting plate it is recommended to use a heat gun to break the Loctite. Use a PH 1 driver.
If servicing, it is recommended that you use red Loctite 263 on the screws to secure the brushless motor to the adapter plate for maximum battle hardening. For Loctite to be effective you MUST wait the recommended cure time for it to set. Battle harden the motors the night before the event, not during the event!
Product may vary in look or color due to sourcing changes.