Our Brushless Drive Kit comes with two of our 1806 2300kv brushless motors paired with our 22mm planetary gearboxes and two 35A BLheli-32 ESCs preprogrammed for bidirectional operation. This means that all you have to do is solder the motors to the ESCs, wire in your battery, and plug them into your receiver to have a fully operational brushless drive for your Beetleweight.
Just like our DDC and Brushed drive kit, our Brushless kit comes with our power distribution boards to make wiring all your ESCs easy.
Kit Contents:
- 2x Rectified Robotics Brushless Planetary Gearmotor
- 2x 35A BLHeli_32 ESC - Preprogrammed Bidirectional
- 1x Rectified Robotics Power Distribution Board pair
Note: If only running "Opto" ESCs (only two wires in PWM cable), you will need a BEC to power your radio receiver. We provide a cheap and powerful BEC here.
Battle Hardening Recommendations:
All motors come with Loctite applied. Loctite 263 is used on the motor gearbox interface, Loctite 243 is used to retain the 4 gearbox screws.
To remove the motor from the mounting plate it is recommended to use a heat gun to break the Loctite. Use a JIS P.1x75 driver.
If servicing, it is recommended that you use red Loctite 263 on the screws to secure the brushless motor to the adapter plate for maximum battle hardening. For Loctite to be effective you MUST wait the recommended cure time for it to set. Battle harden the motors the night before the event, not during the event!
Product may vary in look or color due to sourcing changes.